| A | B |
|---|
| What is the first step when making a special setup? | Contact the teacher. |
| What should you do before making any tool changes or major adjustments? | Contact the teacher. |
| What are the procedures in case of electrical power failure for a piece of equipment with a non magnetic switch? | Turn off,remove board,stand back |
| What is your first step in event of a minor accident? | Notify teacher. |
| What form of protection must be worn in laboratory at all times? | Glasses. |
| Why should the floor be kept clean around machines? | So you don't trip and fall. |
| When you start a machine,why must it attain full speed before cutting? | So you don't break something |
| Why must you not distract a person who is operating a machine? | They could hurt themselves. |
| What is the procedure in case a machine is not running properly? | Turn off,stand clear,contact teacher |
| Why must clothing be confined when running a machine? | Doesn't get caught in machine. |
| What is the procedure if your wood has loose knots or is split? | Tell the teacher. |
| What are the procedure after you are done using a machine? | Turn off and wait for blade to stop. |
| Why should shoes be worn in the laboratory? | So you do not hurt your feet. |
| What will happen to all power machines when the instructor leaves the building? | Machines turned off. |
| What is the safety zone and why is no one supposed to be inside it except the machine operator? | section where the operator stands. no one should be in zone because it well distract the operator |
| Do not feed material faster than it will cut easily? | faster |
| Do not feed material so ______ that wood will burn? | slowly |
| Never do what while the machine is running? | adjustments |
| When running machine give it your full what? | attention |
