| A | B |
|---|
| If you have a board that is tapered 1'' to 3/4'', which end would you put in first? | 3/4'' |
| Where should you stand when turning on the machine? | To the side |
| what should be done with the glue joint before you run the board thru the surfacer? | scrape it off |
| where should you stand when feeding or receiving wood? | on the side |
| what is the procedure in case your board gets stuck in the surfacer? | turn off machine, wait for blade to stop |
| Allow machine to reach what speed before making cut? | full |
| Take off no more than ____of wood at one time? | 1/16'' |
| ______'' is the thinnest wood that can be run thru the surfacer. | 1/2 |
