| A | B |
|---|
| With a board that is tapered from 1" to 3/4", which end would you put in first? | 3/4" |
| Where should you stand when turning on the surfacer? | on the side |
| What should be done with the glue joint before you run the board thru the surfacer? | scrape off the glue |
| Where should you stand when feeding or receiving the wood | on the side* |
| What is the first thing you do if your board gets stuck in the surfacer? | turn off machine |
| What is the second thing you do in your board gets stuck in the surfacer? | wait for the blade to stop |
| What is the third thing you do in your board gets stuck in the surfacer? | lower the table |
| Allow the machine to reach ___ speed before starting a cut. | speed |
| Take off no more than ___ of wood at a time | 1/16" |
| the thinnest wood that can be run through a surfacer | 1/2" |
| The shortest board that can be run through a planer | 14" |
| Always remove ____knots before planing | loose |
| Wait until ___ stops before leaving the area | blade |
| measure the board, then read the _____ on the machine and set machine to correct depth | scale |
