| A | B |
|---|
| Drawings are used to _. | show what to make and the sizes to make it |
| Tolerance are __. | allowances in either oversize or undersize that a part can be made and still be acceptable. |
| When a tolerance is plus and minus, it is called a ___ tolerance. | bilateral |
| When a tolerance is plus or minus, it is called a ___ tolerance. | unilateral |
| A basic dimension is ____. | a numerical value denoting the exact size, profile, orientation, or location of a feature or datum |
| A datum is ___. | an exact point, axis, or plane |
| A vise should be mounted far enough out on the bench edge to ____. | permit clamping long work in a verical position |
| Plier size indicates the ___. | overall length of the tool |
| Torque-limiting wrenches are used when ___. | a threaded fastener must be tightened to specified limtis |
| A torque-limiting wrenches are used when ___. | they are pushed or pulled |
| A pipe wrench will grip round work however___. | the jaws will mar the work |
| The ball-peen hammer is classified according to the ___. | weight of the head without the handle |
| Mount work solidy and as close to the vise as practical for sawing, because if not, ___. | chatter and vibration will dull the blade |
| When sawing, three or more teeth should be cutting at all time; otherwise ___. | the teeth will straddle the section being cut and snap off |
| Files are classified by their shape. File shape is determined by the __. | length and width of the tool |
| Reaming is an operation that will produce a hole that is___. | smooth and accurate |
