| A | B |
|---|
| The term quarter-sawed means _____. | the lumber is cut with the growth rings at an angle greater than 45 degrees |
| The term S-dry on a lumber grade stamp means that the lumber contains _____ moisture | no more than 19 percent |
| Lumber inspection criteria are defined by _____. | umber producing associations |
| Light framing lumber is classified as _____ lumber | dimension |
| Which of the following grade designations represents the lowest quality plywood veneer? | D |
| Which grade of hardboard can be used in exterior applications? | Tempered |
| Which of these types of engineered lumber would be more likely to be used for millwork than as support beams? | LSL |
| Which of the following is not recommended when cutting pressure-treated lumbe | Burn any scrap pieces. |
| Burn any scrap pieces. | 320 |
| A 20-penny nail is approximately _____ long | 4" |
| A nail set is a _____. | tool used to drive finishing nails below the surface of the material |
| Because of its deep threads and holding power, the _____ screw is recommended for use with particleboard and hardboard | sheet metal |
| The _____ is a type of masonry anchor that is set into the concrete while the concrete is still wet. | anchor bolt |
| Which of the following types of sheet material is used in high-wear applications such as concrete forms, cabinets, and countertops? | HDO |
| The type of adhesive that is applied with a dual-cartridge applicator is _____. | epoxy |
| The dimensions of a typical concrete block are _____ inches | 8 × 8 × 16 |
| A buck is a _____. | a frame for making window and door openings |
| Duplex nails are commonly used to _____. | secure concrete form and scaffold members |
| A bolt with an oval, unslotted head is called a _____ bolt | carriage |
