| A | B |
|---|
| is a short chain of monomer liquid that is often thick, sticky, and gel-like and is not long enough to be considered a polymer | oliogmer |
| what is the most common UV bulb on the market | nine-watt |
| light cured gels are usually packeaged in opaque pots or | squeeze tubes |
| the tacky surface left on the nail after a UV or LED gel has cured is called the layer | inhibition |
| is recommended to refine the surface contour for UV or LED gel nails | medium or fine abrasive |
| viscosity is the measurement of the of a liquid and how the fluid flows | thickness |
| which of these products is used to increase adhesion of UV or LED gels to the natural nail plate | bonding gel |
| introducing air into the gel as you apply it to the fingernail will | reduce the stregth of the sured gel |
| which of these is a thick - viscosity resin that allow to build an arch and curve into the fingernail | building gel |
| when gel polish is finish curing , a can be applied over it to created a high, lustrous shine | gloss gel |
| which of theses UV or LED gels cannot be removed with a solvent | hard UV and LED gels |
| which type of gel is also known as soakable gel | soft UV and LED gel |
| light cured gels | can be easy to maintain |
| a very thin - viscosity gel that it used as an alternative to traditional nail lacquers is | a gel polish |
| there are many names for glossing gel, but thet do not include which of the following | layer gel |
| if a light unit has four bulb in it, and each bulb is 9-watt, the the lamp is called a lamp | 36- watt |
| different bulbs produce greatly differing amount of UV and LED light. this is referred to as the UV and LED bulb intensity or | concentration |
| after the nail pate is properly prepared for a light cured gel application, each layer of product is applied to the natural nail, nail tip, or form and requires exposure to a UV or LED light source to | cure or harder |
| gel polish | does not dry the same lacquer |
| a chemical called initiates the polymerization reaction | a photoinitiator |
| the amount of colored pigment concentration in a gel is called | opiacity |
| which product removes surface moisture and tiny amount of oil left on the natural nail plate | nail dehydrator |
| if a client has flat fingernails, which type of product would be recommended | building gel |
| during a gel procedure, keep the brush and open gel containers away from sunlight, gel lamp, | full- spectrum table lamp |
| most LED lamps sure gel four times faster than UV lamp. What do the letters LED represent | light emitting diodes |
