| A | B |
|---|
| Sheet Metal | a piece of thin, flat metal less than 1/2 in. thick and 12 in. or more wide. |
| Scriber | mechanical pencil used to scribe lines on hard surfaces. |
| Beam Compass | used for scribing circles and arcs larger than ordinary compasses and dividers can make. |
| Lever Punch | die and punch that move by levers. |
| Cold Chisel | wedge-shaped tool used for cutting soft sheet metals, band iron, and rivets. |
| Cape Chisel | a cutting edge that is narrower than that of a cold chisel. |
| Round-nose Chisels | a half-round cutting edge. |
| Diamond-point Chisels | tapers to a sharp point. |
| Ball-peen Hammer | has a head shaped to drive and form metals. |
| Cross-peen Hammers | have a beveled peen on the head. |
| Riveting Hammer | used inriveting and in shaping and forming sheet metal. |
| Soft-face Hammer | used for pounding or driving without marring the work. |
| Hand Seamer | tool makes sharp bends near the edges of thin sheet metal. |
| Flux | cleans the metal surface by removing the oxide film. |
