| A | B |
|---|
| Connects circuit boards | RIBBON CABLE |
| 2 | 12-2 BX CABLE |
| 3 | MULTI BUSS |
| used to mechancially connect wires | WIRE NUTS |
| Often used as power cords for coffe makers and vendors | SO 14/2 RUBBER CORD |
| Used to connect power cors to appliance or junction box | 1/2" ROMEX CONNECTOR |
| Stress relief for power cords | 1/2" TOMAC |
| Trips when circiut uses too many amps | CIRCUIT BREAKER |
| hand activated often seen in vending machines and coffe makers | TOGGLE SWITCH |
| Switch in wall cotroling lighting or receptacles | 120V, SINGLE POLE,15 AMP WALL SWITCH |
| Switch that de-activates vendor when door is open | VEND DOOR SWITCH |
| Used to tell if voltage is present at a receptacle or unit | VOLTAGE TESTER |
| protective device found in older buildings | SCREW IN FUSE |
| Switch that is depressed when customer makes selction | VEND SWITCH |
| Small fuse found in microwave ovens or control cicuits | 120V, 15 AMP CERAMIC FUSE |
| Switch that is activated by vend switch | VEND RELAY |
| Usually used tio connect vending machines to power | 3 PRONG,120V,15AMP GROUNDING PLUG |
| Allows 120V connections of 15A max. | 120V, 15 AMP, DUPLEX RECEPTACLE |
| Allows 120Vconnections of 20A max. | 120V, 20 AMP,DUPLEX RECEPTACLE |
| 240V receptacle for larger machineschines | 240V, 20A,SINGLE RECEPTACLE |
| holds ceramic fuses for control circuits in vending machines | PANEL MOUNT CERAMIC FUSE HOLDER |
| holds fuses ceramic fuses in microwave ovens | CERAMIC FUSE BLOCK |
| larher fuse found in disconnect boxes | FERRULE TYPE FUSE |
| 24 | ADAPTOR |
| starts floutescent bulbs | FLOURESCENT BULB STATER |
| moveable holdr for slimline bulbs | SNAP-IN SLIMLINE PLUNGER FLOURESCENT BULB HOLDER |
| Non moving holder for slimline bulbs | SNAP-IN SLIMLINE STATIONARY FLOURESCENT BULB HOLDER |
| the "brains' of a vending machine, can control prices,count vends,etc. | CIRCUIT BOARD |
| special plug for coin mechs | JONES PLUG |
| socket for bulb starter | FLOURESCENT BULB STARTER HOLDER |
| non moving holder for two pin flourescent bulbs | SNAP-IN MEDIUM BI-PIN STATIONARY FLOURESCENT BULB HOLDER |
| moveable holder for two pin flourscent bulbs | SNAP -IN MEDIUM BI-PIN PLUNGER FLOURESCENT BULB HOLDER |
| transformer for smaller bulbs | FLOURESCENT FIXTURE BALLAST, .3 AMP |
| transformer for larger bulbs | FLOURESCENT FIXTURE BALLAST, .65 AMP |
