| A | B |
|---|
| The use of ____________ is required to operate a Drill Press. | Safety Glasses |
| Adjust the drill press to the correct speed so the _____________ will not break. | Drill Bit |
| Be sure the ________ of the drill is seated in the spindle so it will not fall out. | Shank |
| Never leave the_________ in the chuck socket. | Chuck Key |
| Never hold small work in ________ while drilling. | Your Hands |
| Clamp your material to the table or use a drill _________ to keep the drill from catching your work. | Vice Press |
| Never stop revolving work by ________ it. Turn off the machine and step away. | Grabbing |
| Large drills should be run at _______ speeds. | Slow |
| Small Diameter drills may be run at________ speeds. | Higher |
| Drum sanding should be done at no more than _________. | 1200 RPM |
| When drum sanding, feed your material in the __________ direction the drum is turning. | Opposite |
| _________ material to the table so it won't spin around. | Clamp |
| A ________ drill bit allows you to drill multiple diameter holes while using only one bit. | Step Bit |
| Fasten the drill bit securely in the chuck with a _________ key. | Chuck |
| Be sure to accurately_________ your stock before drilling. | Center Punch |
| __________ and roll up your sleeves while using any of our machines. | Tie up long hair |
| _________ up work areas before using a machine. | Clean |
| PPE | Personal Protective Equipment |
