| A | B |
|---|
| When using a hand held grinder | place the item to be worked on in a vise |
| Before changing the blade on any saw | remove the battery or unplug the saw |
| used to cut a 4 foot by 8 foot sheet of plywood | table saw |
| used to cut a small wheel out of 1/4" plywood | band saw |
| used to make a 7/16" hole in a board | drill press |
| used to cut short pieces of aluminum metal | metal cutting band saw |
| used to cut 2 foot pieces of a 2x4 board | miter saw |
| To keep the blade from bending or breaking on a band saw always make sure this is properly adjusted | saw blade tension |
| when changing bits, blades, or other attachments on tools you should use | the wrench designed for that tool |
| do not place finger closer than ____ inches from the path of a saw blade | 4 inches |
| before reaching to pick up a piece of wood you were cutting make sure the machine is | at a full stop |
| Don't cut boards that are | twisted, bowed or warped |
| the part of a saw that you push your work against when cutting is called a | fence |
| large drill bits should always be run | at slow speeds |
| To keep work from spinning due to the blade catching it always | use a clamp or vise to hold the work |
| Never hold small work pieces _____ while drilling a hole in them | in your hands |
| Always get permission ___________ using any saw or grinder | before |
| keep electrical power cords away from | moving blades |
| Only straight lines can be cut with this type of hand held sawsaw | circular |
| Never place hand _________with a blade when cutting | directly in line |
| before backing out of a cut while using a band saw, scroll saw, or any other type of saw, always | turn off the power |
| Make relief cuts when cutting circular or rounded cuts with a saw to | prevent blade from kicking back or bending |
| If a blade breaks while cutting a piece of work | stand back and let the machine coast to a stop |
| Use push bar or a scrap piece of wood to | clean off table or band saw, never use your hand |
| Only cut with a saw when it is at | full speed |
| Make all measurements on your work while machine is | at a stop and unplugged |
| Never turn on a machine unless | you are fixing to use it |
| Never use a hammer that has a | loose head |
| When you are finished using a machine you should | clean it off and unplug it |
| __________annoy or distract another student when in the shop | Never! |
| When unplugging a power cord always | grasp by the plug, not the cord |
| Sharp tools should always be carried facing | downward |
| When sanding or exposed to fine particles you should wear a | particle or face mask |
| When working in the shop, everyone must wear | approved eye protection |
